How to make a slurry from SBR and cement for porcelain tiles outdoors?

Joined
8 Oct 2005
Messages
361
Reaction score
15
Location
Scotland
Country
United Kingdom
Hi there,

I'm using porcelain tiles in the garden. It's quite a 'wet' garden due to run off from the neighbours land so I want to ensure that my tiles are properly primed (I've read that it's crucial with porcelain tiles).

I also read that you can use SBR and cement to make a slurry and just 'paint' it on to the tile.

Is the following SBR and cement suitable?

Everbuild SBR 503 - https://www.amazon.co.uk/dp/B001V9X..._dp_93Z3YHZGYEV7NJWDM4WY?_encoding=UTF8&psc=1

Blue Circle multi purpose cement -
https://www.diy.com/departments/blu...f3QAqcaAs7qEALw_wcB&gclsrc=aw.ds&storeId=1377

And, if so, my next question is - what is the correct mix to make the slurry?

I've read 1 part SBR to 1 part water to 4 parts cement? Is that correct?

Other things I've read say not to use water and just use 1 part SBR to x parts cement?

Anyone got a definitive answer for this?

And... last question that I can't seem to find the answer to.... can I just slurry loads of tiles and leave them for another day before laying them? Or do I need to lay them when the slurry is still wet?? Or - after an hour? Or when the slurry is sticky or whatever?

Thanks for all your help :)
 
Sponsored Links
Sponsored Links
You need to lay while the slurry is still wet. Normally you dip one at a time and then lay immediately.
That's great info. Thanks. Couldn't find out (with quite a few Google searches) which way it was done. I wasn't sure if you could get a load of slabs, slurry them, leave them up against a wall, then do the bed and go and get them one at a time.

Sounds like the process is - do a slab's worth of bed, then slurry the slab, then stick it down (then levelling etc).

Thanks for the information. :)
 
...and clean everything properly before it goes off or you will regret it. Don't assume that, like ordinary mortar, you will knock off any blobs and spills, and get it off your tools...
 
...and clean everything properly before it goes off or you will regret it. Don't assume that, like ordinary mortar, you will knock off any blobs and spills, and get it off your tools...

Thank you. That sounds like you've learned the hard way..... :) :)
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top