How to remove Thermostat when installing Hive

[CHRIS19876]

Hi
I have an existing Drayton wall thermostat , which I need to remove as I have a Hive thermostat to install. There are the 3 wires coming from the backplate of the thermostat.
live goes to bottom of 3 in the wiring centre, wire 3 on thermostat goes to bottom of 2 in wiring centre.
The top number 2 wire in wiring centre goes into the top of number 4 wire in top of wiring centre
The top number of 3 wire goes to the top of 9 in the wiring centre.

9 is heating on

my question is do I simply remove the thermostat wires and bridge 9 to 4 across the top in the wiring centre?

 

[CBW]

Just link 2 and 3 in wiring center for easiness.

 

[gazfen]

Yes join the brown of the valve to the programmer call for heating.

 

[CHRIS19876]

Just link 2 and 3 in wiring center for easiness.

So remove 2-3 bottom wires (red and yellow) and bridge those?

 

[CBW]

So remove 2-3 bottom wires (red and yellow) and bridge those?

Yes, in order to bridge them across.

 

[CHRIS19876]

Hi ,sorry I’ve been away! so I’ve shown in the drawing what I’ll do , basically Exhibit A connect 2 and 3 with small cable , correct? last time I post a question - the next post will be a success story!

 

[CBW]

@CHRIS19876 - having revisited this’ll, I’ve realised, yes you should remove the bottom wires, otherwise they will be live the other end.

 

[CBW]

Hi ,sorry I’ve been away! so I’ve shown in the drawing what I’ll do , basically Exhibit A connect 2 and 3 with small cable , correct? last time I post a question - the next post will be a success story!

Yes, looks ok to me.

 

[CHRIS19876]

@CHRIS19876 - having revisited this’ll, I’ve realised, yes you should remove the bottom wires, otherwise they will be live the other end.

Yes I was going to do , thanks

 

[CHRIS19876]

All works thanks for all your help!

Yes I was going to do , thanks

 

[CBW]

All works thanks for all your help!

No problem, glad it’s working