I am replacing the old storage tank in the loft.
The existing vent pipe from the indirect cylinder below is not high enough above the tank water level so I will need to extend it. Also the existing 180 degree vent pipe U-bend has been formed with two elbow connectors and short lengths of pipe.
Is it OK for the U-bend to be made up like this or should it be formed in one piece with a pipe bender?
The existing vent pipe from the indirect cylinder below is not high enough above the tank water level so I will need to extend it. Also the existing 180 degree vent pipe U-bend has been formed with two elbow connectors and short lengths of pipe.
Is it OK for the U-bend to be made up like this or should it be formed in one piece with a pipe bender?