Hi Guys
I need a little advice, I have a brand new Ideal Istor boiler (well I bought it a few months ago) and it has been fitted today.
I did all the pipework to the frame and all that was needed to be done by the engineer was fit the flu and gas pipes and commission it. all pipework was checked (only went to a single underfloor heating manifold) and DHW so easy to do and check.
On testing he got an error almost straight away, it comes up with 6 in the display and then after about 5 seconds you get H:E it has also come up with L:E with the burner light on too.
He has said that it is going to need a new PCB, can anyone confirm that a brand new boiler that has never been used, could need a new PCB.
Is there any way of re-setting it.
Many Thanks
Pat
I need a little advice, I have a brand new Ideal Istor boiler (well I bought it a few months ago) and it has been fitted today.
I did all the pipework to the frame and all that was needed to be done by the engineer was fit the flu and gas pipes and commission it. all pipework was checked (only went to a single underfloor heating manifold) and DHW so easy to do and check.
On testing he got an error almost straight away, it comes up with 6 in the display and then after about 5 seconds you get H:E it has also come up with L:E with the burner light on too.
He has said that it is going to need a new PCB, can anyone confirm that a brand new boiler that has never been used, could need a new PCB.
Is there any way of re-setting it.
Many Thanks
Pat