I need to install a few Downlights into an existing ceiling. I don’t have access above this ceiling.
I’ve seen a few different methods where you can poke a small hole in the ceiling and inspect for obstructing joists before cutting out hole for Downlight.
I recently pushed a small screwdriver in all directions but then realised that I was very close to a joist - after I cut the holesaw.
Is there a simple and sure way to do this?
Thanks in advance.
I’ve seen a few different methods where you can poke a small hole in the ceiling and inspect for obstructing joists before cutting out hole for Downlight.
I recently pushed a small screwdriver in all directions but then realised that I was very close to a joist - after I cut the holesaw.
Is there a simple and sure way to do this?
Thanks in advance.