Installing a dual-tech PIR with just 6 cores

[Neil Coleclough]

I need to replace 4 sensors on a zone that occasionally false activates. I have bought Honeywell Activ8 AM-DT anti mask quad PIR and Microwave sensors, but they appear to need 8 cores back to the panel. Because this is a retrofit, I only have 6 cores.

The installation instructions refer to this wiring configuration:-

Terminals 1&2 = tamper circuit

Terminals 3&4 = R-AM (output relay Anti Mask contacts of the detector. Connect to a normally closed zone in the control panel).

Terminal 5 = End of line option

Terminals 6&7 = R-PIR (output relay PIR contacts of the detector. Connect to a normally closed zone in the control panel).

Terminal 8 = +12v

Terminal 9 = GND


Is there an easy way of connecting this back to the control panel with just 6 cores by using jumpers for example?

 

[Europlex]

Just don't use 3,4 & 5, simples

 

[Neil Coleclough]

Thanks for that Europlex!
I was assuming that the output from 3&4 was one "tech" and the output from 6&7 was effectively the "dual tech"
What exactly is "R-AM output relay Anti Mask contacts of the detector" and is it something that I don't need?

Read more: http://www.diynot.com/diy/threads/installing-a-dual-tech-pir-with-just-6-cores.460834/#ixzz4B5OSMh1l

 

[sparkymarka]

Yes, you don't need the anti mask unless your installing to grade 3 , as a diy you won't ...