Hi everyone,
As per the subject line, I am looking to install a Honeywell DT92E wireless thermostat into my heating system's existing Danfoss WB12 wiring box to control our home's central heating.
The system has never had a CH thermostat before, but there is a analog fitted one on the HW cylinder.
Looking at the wiring diagrams for both the thermostat and junction box it appears to be a simple three-wire connection between the two units, plus a wire linking L to A within the thermostat.
However, before I purchase the thermostat I was hoping someone on here could confirm that my assumptions are correct, and whether there is anything else I should be aware of??
The system programmer is a Danfoss FP715, the boiler a Potterton Prima 60F. HW and CH circuits are both fitted with Sunvic SZ2301 actuators.
Thanks in advance,
Mark
As per the subject line, I am looking to install a Honeywell DT92E wireless thermostat into my heating system's existing Danfoss WB12 wiring box to control our home's central heating.
The system has never had a CH thermostat before, but there is a analog fitted one on the HW cylinder.
Looking at the wiring diagrams for both the thermostat and junction box it appears to be a simple three-wire connection between the two units, plus a wire linking L to A within the thermostat.
However, before I purchase the thermostat I was hoping someone on here could confirm that my assumptions are correct, and whether there is anything else I should be aware of??
The system programmer is a Danfoss FP715, the boiler a Potterton Prima 60F. HW and CH circuits are both fitted with Sunvic SZ2301 actuators.
Thanks in advance,
Mark