Installing laminate floor up to bi-fold door threshold

[addey]

I am about to lay quickstep laminate floor throughout the downstairs of my newly renovated house. The skirting boards are all off so they will be replaced to hide the expansion gaps, however I'm stuck as to how to finish the floor where it butts up to the bi-fold doors? The bi-folds are 3.6m wide and the floor boards will be running end-on to the door frame. Assuming I have to leave an expansion gap here I will be left with ~10mm gap with no way of covering it. It will only be accentuated by the fact that there will be 15 or so board ends which are unlikely to create a perfectly straight line!

Are there any solutions to this problem?

 

[footprints]

Quickstep incizo threshold comes in just over 2m lengths if you can live with a butted up join in the middle.

 

[addey]

Thanks for your reply. I had looked at the incizo and thought that would be a possibility. I need to get some for a threshold between rooms so that will give me a chance to see what it is like.

 

[mr_vampy]

You could use the Incizo made by Quickstep, or you can use a square edge bar like this.
http://www.wilko.com/carpet-accesso...m-square-edge-gold-m233-90cmx3cm/invt/0238293

There's another one which is just a L shaped square edge and that is self adhesive and can be stuck to the floor afterwards.

They're available in 8ft lengths.