Hi there. Thanks in advance for assistance given.
I have removed the brickwork to install the padstone. Padstone size is 420x220x100.
Working back from the joist to the existing wall I have 470. Steel is 202, padstone is 220, leaving a nice 50 mm to fill in.
Am I best filling this with a cut down brick or can I fit the padstone straight onto 40 to 50 mm of 2.5/1 mix.
Also the padstone is not square on the top edge but slopes slightly. Abit of a pain this.
Any advice?
I have removed the brickwork to install the padstone. Padstone size is 420x220x100.
Working back from the joist to the existing wall I have 470. Steel is 202, padstone is 220, leaving a nice 50 mm to fill in.
Am I best filling this with a cut down brick or can I fit the padstone straight onto 40 to 50 mm of 2.5/1 mix.
Also the padstone is not square on the top edge but slopes slightly. Abit of a pain this.
Any advice?