Kintec extension speaker

[Lee Woods]

Hi, could anyone tell me how to wire a Kintec extension speaker to a Honeywell galaxy G2 panel? The speaker only has two wires (red and black) it should have been a straight swap of the existing speaker with a red and black cable going to the same outputs on the panel, however when the alarm goes off the speaker makes a tiny little noise as if the speaker is burst (it is not) so I’m looking for some guidance.
Lee.

 

[sparkymarka]

Was the old one a speaker or a sounder ? Or even a speaker that had a pcb inside to convert sounder to speaker ….
Post picture of existing speaker

 

[sparkymarka]

Also see below

 

[Lee Woods]

Hello Thanks for your reply. Please see below - the cable currently is connected to output 1003 on the panel and the red in the positive power section.

 

[sparkymarka]

That’s a sounder …..not a speaker …what’s wrong with it ? Apart from its stuffed with tissue paper and tape….
What are you trying to do ?

 

[Lee Woods]

It is being replaced with the Kintec unit. The only issue is the cabling will be different as the current set up is wired to output 1003. All I need to know is where to connect the Kintec wires to on the panel.
Lee.

 

[sparkymarka]

Did you not read the screen shots sent !

 

[Lee Woods]

It doesn’t indicate if it’s the red or black cable that goes there so it’s not very clear. I don’t have much experience with this I work in a school and they have asked me to switch it over.

 

[sparkymarka]

Jesus ….
Ok if the wires are back in the panel , remove the black wire which should be in bell trig and put in speaker terminal
IF ITS PROGRAMMED FOR SPEAKER AND NOT BEEN CHANGED ! …..you may have allready damaged the speaker by wiring it in the first place !

 

[Lee Woods]

Thanks for your help and understanding.