I have installed three sets of B&Q LED downlighters under my kitchen cabinets. Two sets of 2 and a set of 5. One set of 2 are supplied by a cable which is powering a set of 2 LED downlighters inside a cabinet and the set of 5 is supplied by a cable which is powering a set of 4 LED downlighters inside two cabinets. They are all coming off the same switch. The 6 lights inside the cabinets are working fine. I am getting nothing from those 9 under the cabinets. Has anyone any ideas what I am missing, as I am now stuck?
I have just popped one of the under cabinet lamps into the inside cabinet driver and the lamp lights up, so the lamps are ok.
The working LED lights are off two tiny drivers with IN 240V 50Hz and OUT DC12V.
The non working LED lights are off three bigger drivers with Pri-220-240 VAC 50/60Hz and Sec-DC12V Max 1.25A 15W
Thank you
I have just popped one of the under cabinet lamps into the inside cabinet driver and the lamp lights up, so the lamps are ok.
The working LED lights are off two tiny drivers with IN 240V 50Hz and OUT DC12V.
The non working LED lights are off three bigger drivers with Pri-220-240 VAC 50/60Hz and Sec-DC12V Max 1.25A 15W
Thank you