Lately getting lots of failed led fittings, usually it appears the drivers have failed and in the emergency fittings the electronics failed.
The led elements, varying from say 10 elements to say 40 elements are usually on there own printed circuit with + and - marked on the end of the board.
These appear fine and I'm sure still ok.
I am sure it is not as simple as applying voltage across the end, as they are expecting a constant current aprox 350ma.
My question is can a simple circuit be made to run these strips of 12 volt DC to make up some basic light boxes that can be used in a van.
Thanks in advance
The led elements, varying from say 10 elements to say 40 elements are usually on there own printed circuit with + and - marked on the end of the board.
These appear fine and I'm sure still ok.
I am sure it is not as simple as applying voltage across the end, as they are expecting a constant current aprox 350ma.
My question is can a simple circuit be made to run these strips of 12 volt DC to make up some basic light boxes that can be used in a van.
Thanks in advance