Hi all,
I'm laying cement tiles in a small hall area which was previously floorboards. I've screwed down plywood, laid thinset mortar and Ditramat - and I was going to tile onto this but it's not very level. Purely down to my lack of skimming skill - the matting is a bit wavy.
- Will the next level of thinset sort this out? - should I go ahead and tile?
- Is it fixable with some self levelling compound on top of the ditramat?
- Should I rip up the ditramat and put SLC onto the thinset, then reapply the ditramat?
- Do I have to rip it all up and start again?
I realise this was a bit ambitious but I'm determined to finish it...
I'm laying cement tiles in a small hall area which was previously floorboards. I've screwed down plywood, laid thinset mortar and Ditramat - and I was going to tile onto this but it's not very level. Purely down to my lack of skimming skill - the matting is a bit wavy.
- Will the next level of thinset sort this out? - should I go ahead and tile?
- Is it fixable with some self levelling compound on top of the ditramat?
- Should I rip up the ditramat and put SLC onto the thinset, then reapply the ditramat?
- Do I have to rip it all up and start again?
I realise this was a bit ambitious but I'm determined to finish it...