Making changes to stairs and building regulations..

Joined
26 Jun 2007
Messages
88
Reaction score
0
Location
Nottingham
Country
United Kingdom
Hi all,

We're looking to make some alterations to the stairs in our house and want to know what building regs, if any, we will need to adhere to, and whether the whole staircase will need to be replaced/widened.

The current stairs are in the middle of the house and are surrounded by walls either side (no balustrade/banister/railings). They measure 86cm wide and lead straight down to the garage.

There are some basement rooms either side, and we want to make the staircase "bend" into one of the rooms (just the last few steps), rather than lead straight into the garage. That will obviously mean knocking down one of the walls and installing an RSJ (presume separate building regs/structural engineer will be required for that).

Would we need to replace the whole staircase and make it wider to conform to building regs, or could we just install the "bend" at the bottom maintaining the current width?

Thanks in advance.
 
Sponsored Links
You do not need to conform to the latest regs, just make it no worse than existing. BTW you can do a 600mm stair in a house. Obviously anything structural and anything that affects the layout in terms of protected escape routes etc needs to be taken into consideration.
 
There are some basement rooms either side, and we want to make the staircase "bend" into one of the rooms (just the last few steps), rather than lead straight into the garage. That will obviously mean knocking down one of the walls and installing an RSJ (presume separate building regs/structural engineer will be required for that).

Is your garage in the basement??
 
Is your garage in the basement??

Yes :) It's more a partial basement - partially underground, you walk in the house on the top level, but the garden and garage are on the bottom level.

It's certainly an odd one ;)
 
Sponsored Links
"good paractice" on stairs is to make any landing at least as long as the stair width, so extend the stair tread at the point you wish and then build your new stiars off the side. It is better to keep all the risers and goings on a stair the same even after a change of direction, as uneven stairs trip people.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top