Microbore Pipe bender

Sponsored Links
Sponsored Links
Got an irwin one from bes for about 17=18 quid
spot on nice clean tight bents!
Ive also found out myself that some silverline stuff is sh1t
 
just ordered one thanks for that mate i looked on ebay and that one was about quid cheaper than on ebay
 
you could fill the pipe with water and freeze it..
that's how they bent the pipes on a trumpet... :)
 
the only time i use microbore for rads etc is using the harder table x stuff. it only comes in 3 meters like usual.but the end results are you get better runs and easier to bend, without the usual flatening.
 
I usually find that if you are using microbore, if you are careful, you can bend it as it is. Obviously bends can't be too tight, but if you keep moving the pipe as you bend, so that you're not bending in the same spot, its OK.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top