Hi
The end bit of the mixer tap has just fell off. I'm struggling to get in back on correctly. Does the threaded bit go in first or the plastic bit? Is it knackered once it falls out?
usually the plastic bit (with holes/slots in it?) goes into the threaded bit and that screws back into the spouty endy bit Can you put a pic of it on so we can see if it's broken or not?
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local