Moving a Texecom Premier Elite 64

[craftycooky]

Hi,

I am looking to move an existing Elite 64 from one house to another.

Its completely wireless and would use the same set up on the new location.

Any recommendations on the best/easiest way to do this.

My thinking is, engineer code, take out all the batteries, disconnect the mains and battery from the panel. Reinstall the pir's, keypad and panel. put all the batteries back and connect the mains. Will this work or is there a better way.

Many Thanks

Dave

 

[secureiam]

if your moving house due to sale, you have to make sure it was clear the alarm was not included.

place in engineers mode , disable the bell, remove all the batteries, remove all the devices, I would use new batteries at the new house.

 

[The Pars]

Mark up all devices with zone numbers so when you reinstall you just need to change the device location name.

 

[Handymanjo]

I'm with Secure , make sure you stated the alarm was not included in the sale of the property.

 

[craftycooky]

Thanks very much for your help.
We have shown it as not included on the house move form.

When re installing I guess its connect the battery and mains to to control panel, then new batteries in the PIRs, keypad etc.

Once the new batteries are back in will the PIRs etc. just reconnect or will they need to be relearnt.

Thanks
Dave

 

[secureiam]

power it all back up, and put in commissioning mode