- Joined
- 11 Sep 2007
- Messages
- 769
- Reaction score
- 31
- Country
Hi Guys,
Need to refit a cloackroom, which at the mo only has cold water supplies.
I need to add basin, so obviously need hot water in there, the cloakroom is situated pretty much directly below the cylinder, my question is where is the best place to take a tee from?
I was hoping that when the hot supply comes out of the top of cylinder and drops down to below the floor boards, then off at an angle across the house to feed the bathrooms and then kitchen below, I could tap into the 22mm down pipe as it enters the ceiling/floorboard void.
Just wondered if this will cause any problems with the current supply etc?
Need to refit a cloackroom, which at the mo only has cold water supplies.
I need to add basin, so obviously need hot water in there, the cloakroom is situated pretty much directly below the cylinder, my question is where is the best place to take a tee from?
I was hoping that when the hot supply comes out of the top of cylinder and drops down to below the floor boards, then off at an angle across the house to feed the bathrooms and then kitchen below, I could tap into the 22mm down pipe as it enters the ceiling/floorboard void.
Just wondered if this will cause any problems with the current supply etc?
