I’ve replaced my Danfoss wall stat with a Salus wireless unit. I got the RT310RF pack, which contains the RT310TX stat/transmitter and RXRT510 receiver, already paired apparently.
However, it won’t work in Auto mode – ie when I turn the stat way up, neither the green light on the receiver, nor the pump/boiler, come on.
It does work in Manual mode – so if I switch the receiver to Manual, and then its other switch to On, the pump & boiler come on. So I guess my wiring’s OK – not much to it anyway, just Live, Neutral, Common (jumpered to Live), and Switched.
Any ideas please? I suppose I could go and try pairing it, but am reluctant for two reasons: (1) the instructions are incomprehensible; (2) they do say when it’s successfully paired, the red LED will be on… and it is.
Right now, I’ve put it in an unheated room (about 16o), very close to the receiver (like 6’ through a single door) and set the stat to 25o – but nothing.
Thanks…
However, it won’t work in Auto mode – ie when I turn the stat way up, neither the green light on the receiver, nor the pump/boiler, come on.
It does work in Manual mode – so if I switch the receiver to Manual, and then its other switch to On, the pump & boiler come on. So I guess my wiring’s OK – not much to it anyway, just Live, Neutral, Common (jumpered to Live), and Switched.
Any ideas please? I suppose I could go and try pairing it, but am reluctant for two reasons: (1) the instructions are incomprehensible; (2) they do say when it’s successfully paired, the red LED will be on… and it is.
Right now, I’ve put it in an unheated room (about 16o), very close to the receiver (like 6’ through a single door) and set the stat to 25o – but nothing.
Thanks…