Hi All, I'm tearing my hair out trying to get my newly installed Showerforce 9.5kW shower working. I've even had them send me a new solenoid and pressure thingy (yellow thing that pops up when there's sufficient water pressure). Basically, when I screw every thing in and turn it on it initially it works perfectly - I run it for 60 seconds on cold with the temperature dial to max as suggested for running first time, then reduce the temperature to midway then up the power to medium or high. All perfect. Until I switch the power to off and try to switch it on again... no water flow. The low pressure light is on. And yet the pressure was fine before, in fact very good. I'm thinking the solenoid works okay it's just the power is not getting to it. Or am I getting this all wrong? The soilenoid came with a new board and when I connect this I get the following - switch the power to cold and it comes on for about 7 seconds (phased shut down?) and then the water switches off with the low pressure light on. Switch the power to off and the water suddenly comes on again for another 7 seconds (phased shutdown again?). Any help or suggestions would be brilliant. The shower is on it's own circuit with a big 6mm cable and an RCD fitted by an electrician. Please help! Jo