Optima G3 Tamper problem

[securespark]

Have you got a stand alone RKP?

My Accenta RKP tamper switch broke so that sometimes when keying in numbers, the tamper went off. I thought initially it was the keypad PA set off, but when I opened up the RKP, the broken spring fell out...

 

[joefeehan]

How do i sort a problem with my home security alarm, the texecom(the name of my alarm) it is the tamper for the magnetic door contact that i am having troubles with. hope you can get back to A.S.A.P thanks

Joe Feehan

 

[Alarm]

Check the connections, at each end.
In the panel there will be a few in series in connector strip.
At the contact a twisted pair under the silver screw.


As for the OP, does it happen as you walk in certain places.

 

[Alarm]

It's nearly always the bellbox tamper switch. It's the only tamper that is subject to moisture and corrosion. Link it out for a while and see what happens.

Oh and it can be (rare though) the tamper on your door contacts.

Wrong on both counts as per.

 

[riveralt]

It's nearly always the bellbox tamper switch. It's the only tamper that is subject to moisture and corrosion. Link it out for a while and see what happens.

Oh and it can be (rare though) the tamper on your door contacts.

Wrong on both counts as per.

Over four years after the event - I would hope OP has sorted out his problems by now

 

[Alarm]

I was in the main replying to the one dated

: Mon Dec 12, 2011 9:12 pm

 

[riveralt]

I was in the main replying to the one dated

: Mon Dec 12, 2011 9:12 pm

So sorry, I thought you were also talking about Joe-90's 2007 response.

 

[Alarm]

I added that as a pointer to its inaccuracies.

 

[Tiggr69]

hi have disconnected all cables zones tampers etc have put loops in the PA , tamp , ta of the bell and tamp of the rkp . when power put on power led lights up red . put RKP cables back in left loop in tamper and RKP is showing tamper fault . my assumption it is the main PCB Board at fault , anyone any other idea ??? Battery is flat and needs changed
thanks
Gordon

 

[sparkymarka]

Did you press reset ? Is the panel lid on ?

 

[Tiggr69]

Did you press reset ? Is the panel lid on ?

panel lid is on and secured . yes on the RKP as panel does not have one ??

 

[sparkymarka]

That's maybe your problem ! There should be a spring tamper on panel it may have come off ! Switch above panic terminals google manual page 4 sw1 on pcb diagram...