Hi All
I am looking to remove a tap that is in an old shed.
It would appear the pipe work is 3/4 inch plastic (like mdpe, but older?!?).
The best place to blank it is at a T Under the shed floor, the other flow pipe going to an outside tap that I want to keep.
I have been looking for either a 3/4 to 3/4 90 degree bend, or a 3/4 stop end - but I am struggling as all I can find is adaptors to get to 15/22mm.
I have considered getting an adaptor, then a small amount of copper pipe, then a 15mm stop end - but this seems like a crappy bodge and there isnt a huge amount of room in the area under the floor.
Can anyone point me in a direction where I can get either a 3/4 Brass Stop End, or a 3/4 Brass 90? Or am I missing something obvious?
I've tried a 22mm stop end, and its too big.
Cheers in advance
I am looking to remove a tap that is in an old shed.
It would appear the pipe work is 3/4 inch plastic (like mdpe, but older?!?).
The best place to blank it is at a T Under the shed floor, the other flow pipe going to an outside tap that I want to keep.
I have been looking for either a 3/4 to 3/4 90 degree bend, or a 3/4 stop end - but I am struggling as all I can find is adaptors to get to 15/22mm.
I have considered getting an adaptor, then a small amount of copper pipe, then a 15mm stop end - but this seems like a crappy bodge and there isnt a huge amount of room in the area under the floor.
Can anyone point me in a direction where I can get either a 3/4 Brass Stop End, or a 3/4 Brass 90? Or am I missing something obvious?
I've tried a 22mm stop end, and its too big.
Cheers in advance