PIR sensors not that responsive

[CSM Security]

Hi all,

I currently fit Pyronix systems, but last couple I've done the PIR sensors wasn't that responsive when alarm is set. They learnt with no problem at all & signal strength was good. Anyone had this issue?

Regards,
Chris

 

[sparkymarka]

Was the pet insert still in ?

 

[CSM Security]

It was, thanks for your reply

 

[scott1980]

Not surprised then, Enforcer PIRs with the pet lense fitted would struggle to pick up an elephant walking past them. Always remove the filter, if they have pets go for perimeter detection (can't say I can recommend the Pyronix shock sensors for this, either)

 

[CSM Security]

Thanks Scott, I'm going to remove them tomorrow and re-test. Thanks for the reply.