Pixelation on Panasonic LCD TV

[DIYspanner]

Model TXL32-C2B

I auto-tuned yet still got pixelation with bad signal flagging up. Roku stick on HDMI is perfect.

I've plugged a spare TV in to the same aerial cable and that is perfectly fine for DTV.

I've had the back off looking for bad caps and loose cables. The only thing I've found is the centre pin on the aerial socket is a bit wobbly but still has good continuity to the first pin on the base.

A bad board perhaps?

 

[freddiemercurystwin]

Time for a new TV ....

 

[securespark]

It's potentially up to 16 years old.

If it were me, I'd treat myself to a new one. An early Christmas prezzie!

 

[Rodders53]

Why auto tune --- last thing to be done when you get a reception problem! (Sometimes due to things outwith your control that will auto correct when a fault - such as continental interference or a transmitter problem goes away).

Anyways:
Gently nip the aerial centre pin/socket up a tad... Then use the signal condition meter to check you are on the correct transmitter frequencies. Old DVB-T (SD only) sets from that time may find and store the low frequency channels found first and ignore 'better' ones later in the scan. Use https://www.freeview.co.uk/corporate/detailed-transmitter-information to get the transmit frequency channel numbers to confirm.
Manually scan to correct any anomalies.

That era of Panny TV signal meter is likely on a scale of 0-10 for Signal and 0-10 for Quality but both post agc and error correction so often 10/10 for both unless very marginal location. Q is always more important than S.

Possible that over time aerial cable strain has damaged the connections inside the tuner can... if so a new TV would be the answer (DVB-T2 HD this time).

 

[Wayners]

TV has signal strength and quality meter built in. What's that saying