I need to re-locate my central heating boiler, an oil fired Worcester Danesmoor 12/14, to allow me to knock an entrance into my house from an attached outbuilding. I'm going to struggle to meet the maximum of 2 x 135 deg bends in the flue to line up with the 40ft chimney on the outside of the house from the new boiler location.
Has anyone any experience of, or know if you can fit a power flue to this type of system to allow me to use a greater number or sharper angle of bends in the flue?
Has anyone any experience of, or know if you can fit a power flue to this type of system to allow me to use a greater number or sharper angle of bends in the flue?
