Power saws and floor boards.

[wolfboy]

What's the best way of getting up a section of tounge & groove chip board flooring. Is the only way to use a circular saw with a depth control on the blade. If so can you recommend a model that is reasonably priced but will do a good job.


Wolfboy.

 

[big-all]

heeelllooo wolfboy
have a look at this thread //www.diynot.com/forums/viewtopic.php?t=81133&highlight=

although its about drills the set i recomend and have myself includes a thin kerf blade at 1.5 mm that will easily do your job if you avoid the nails

 

[gcol]

Search and ye shall find.
//www.diynot.com/forums/viewtopic.php?t=79555