Pyronix enforcer lost engineer code - how hard to reprogram?

[km011b3870]

Hey everyone

I think we've lost the engineer code so from what I've seen the only thing I can do is reset the panel. From what I gather I would then need to relearn all the inputs and the bell. What's involved next?

We have 2 floors. The way it's set just now we can have jus the top floor or all floors. The other thing, there's a front and rear exit with door contacts. There's also a pir when coming in through the front and a PIR when coming in through the back (actually there are 2 pirs that would be crossed to reach the panel from the rear).

Is it complicated to setup the system again as it is? When we open the front door and set the alarm it says to exit via front door and likewise for the rear door. To get to/from the rear door you need to cross 2 pirs and the front door it's 1.

Thanks

 

[secureiam]

look at code default videos on you tube

 

[sparkymarka]

No need to default panel as there is a back door into
The panel ….

 

[secureiam]

There is a video with it on you tube but labelled as default codes.