Pyronix Enforcer, setting countdown

[Hmac87]

Hi
Im not sure if anybody can help.
I fitted the enforcer system myself.
It is all working fine but I can't seem to work out how to get the system to count down when I walk in the front door.
I keep forgetting the alarm is on and walking past the panel and setting it off in the living room.
My old alarm used to count down when I opened the door. This alarm counts down but only when I leave.
Any help would be greatly appreciated.

 

[sparkymarka]

Do you have a door contact ?

 

[Hmac87]

Hi
Yes I have a door contact on the front door. But I don't have a PIR as I walk in. I have one in the kitchen and one in the lounge.
Thank you again

 

[sparkymarka]

Is the contact programmed in correctly and set to full set A if your using A for full ? Is it set to chime ? Does it chime ?

 

[Covertop]

Make sure you have set the door contact as Final Exit. in Change Inputs. Its code 07

 

[Hmac87]

Hi
I have A part set and B full set.
The contact does chime and it is also set to 07 final exit.
Thank you for your replies.

 

[Covertop]

Hi
I have A part set and B full set.
The contact does chime and it is also set to 07 final exit.
Thank you for your replies.

Go in to timings then and check what the timings are up for B. It may be different to preset A, .
What method are you using to arm it.
Word case
Failing that delete the contact and re add it and re set it up correctly.