- Joined
- 6 Feb 2019
- Messages
- 2
- Reaction score
- 0
- Country
I have installed a new Pyronix Enforcer 10 Alarm and want to operate it via the remote control fob.
I can set it by pressing the lock button and can unset the system using the fob up to the point where it fully arms, after that, the unlock button flashes red and doesnt un arm the panel.
However, if I enter a zone where a PIR is on the entry / exit route and the panel starts to count down, the fob will unset it.
Any ideas what's going on or does the remote need a trigger before it will un set the system
I can set it by pressing the lock button and can unset the system using the fob up to the point where it fully arms, after that, the unlock button flashes red and doesnt un arm the panel.
However, if I enter a zone where a PIR is on the entry / exit route and the panel starts to count down, the fob will unset it.
Any ideas what's going on or does the remote need a trigger before it will un set the system