Hi,
Please can someone help me, I have just installed a Pyronix Sterling 10 alarm system and have connected a Texecom Odyssey E/1 bellbox. Everything seems to work fine except the siren and strobe on the Texecom bellbox won't activate when the alarm is triggered. The internal sounder activates ok when the alarm triggers. Also when I try to do a System Test from the control panel for the strobe and siren nothing happens, again the sounder test works fine.
I can confirm the siren on the bellbox will activate when in tamper mode (removing the cover off the bellbox) and also the strobe was tested by connecting the strobe (S) on the bellbox to Bell- on the panel, so I can confirm the siren and strobe do work just not in alarm activation.
I have connected the panel to the bellbox as follows (Sterling 10 first):
Strobe C, Bell C & Bell- = D
Strobe N/O = S
Bell N/O = B
BT = C
Bell+ = A
FYI - the internal Sounder is connected to Bell N/O and works fine in alarm activation.
Please can you advise why the siren and strobe may not be activating, is the wiring correct or is there a setting on bellbox that could be causing this? I believe the Texecom bellbox is compatible to use on the Sterling 10.
I would really appreciate some help as I believe I have tried everything and still cannot get the siren or strobe to activate.
Thanks
Pav
Please can someone help me, I have just installed a Pyronix Sterling 10 alarm system and have connected a Texecom Odyssey E/1 bellbox. Everything seems to work fine except the siren and strobe on the Texecom bellbox won't activate when the alarm is triggered. The internal sounder activates ok when the alarm triggers. Also when I try to do a System Test from the control panel for the strobe and siren nothing happens, again the sounder test works fine.
I can confirm the siren on the bellbox will activate when in tamper mode (removing the cover off the bellbox) and also the strobe was tested by connecting the strobe (S) on the bellbox to Bell- on the panel, so I can confirm the siren and strobe do work just not in alarm activation.
I have connected the panel to the bellbox as follows (Sterling 10 first):
Strobe C, Bell C & Bell- = D
Strobe N/O = S
Bell N/O = B
BT = C
Bell+ = A
FYI - the internal Sounder is connected to Bell N/O and works fine in alarm activation.
Please can you advise why the siren and strobe may not be activating, is the wiring correct or is there a setting on bellbox that could be causing this? I believe the Texecom bellbox is compatible to use on the Sterling 10.
I would really appreciate some help as I believe I have tried everything and still cannot get the siren or strobe to activate.
Thanks
Pav