Pyronix v11 upgrade for end user

[Hoptoit]

Hi, can’t find an answer to this so if it’s been asked before apologies.
I have a v9 and would like to upgrade to cloud arm disarm / current installer has panel locked down fully and is slow to respond etc, so I’m thinking my best solution is to cut him out of the loop and fit a new v11 panel and start from scratch.
I have 5 pir and 2 door sensors so nothing over complex programming wise., and looking at the manuals seems straight forward. I also understand that I get zero support from Pyronix in case of issue, but that’s pretty much where I am now with a crap installer, but at least I will own the engineer code!
So I’m pretty sure the board change etc is fine to do but what about registering it all into the cloud, does that work without an installer account or will I get blocked as I try to set that up?

Thanks

 

[secureiam]

The upgrade kit i easyish to install.

The first year app is free after which you can shop around for the best value.

If your wanting support then there is plenty on here.