Hi,
A couple of days ago I bought some 18mm structural plywood. I had it cut up for transport by the supplier. Below are a couple of pictures. As you can see, in one place a split in the surface has been filled (the split is just the top layer of the plywood).
It isn't a problem for me in this case, because I am just cutting the board down further to make gussets, but I just wondered if this was typical (this is the first time I have bought it), and whether it is acceptable.
A couple of days ago I bought some 18mm structural plywood. I had it cut up for transport by the supplier. Below are a couple of pictures. As you can see, in one place a split in the surface has been filled (the split is just the top layer of the plywood).
It isn't a problem for me in this case, because I am just cutting the board down further to make gussets, but I just wondered if this was typical (this is the first time I have bought it), and whether it is acceptable.
