Quick Arm Texecom problems

[ninjin]

Hi guys.

Been trying to set up the quick arm function in my texecom elite 24.

I have wintex.

I have so far activated the quick arm function and the part arm works perfectly.

However, the full arm does not seem to be working.

When I press the button for full arm it goes into a long tone with "A." in the display. When I open the front door it is not shown on the displayed.

Can anyone tell me where I have gone wrong?

In addition, when I first installed the system, the Keypad display would welcome me back when I disarmed. Now, it only welcomes me back when I enter my code from standby. Can I switch it back to welcome me back from disarm?

Thanks in advance.

 

[ninjin]

Just been playing around some more and I think I have bodged up something!

Now the system is telling me I have tamper on front door!

that's why I guess it didnt pick up the door opening.

on my keypad when I cycle though zones, I can no longer see zone 9 either....

 

[ninjin]

found the problem. When I activated quick arm it screwed up my system.

After going back and resetting everything, then activating changes one by one its now fully working!

So my advice, dont make too many changes on wintex before uploading!