Rafter Questions

Joined
28 Oct 2026
Messages
3
Reaction score
0
Country
United Kingdom
Good evening guys

On my 1930's house I have rafters not actually touching the ridge board. There is a 5-13mm gap between some of the rafters and the board There is single nail which connects the board and the rafters.

Can you please advise on how to react to this. Does it need nothing, or correcting back flush to the ridge board, or reinforcement with extra ties?
 
Last edited:
Good evening guys

On my 1930's house I have rafters not actually touching the ridge board. There is a 5-13mm gap between some of the rafters and the board There is single nail which connects the board and the rafters.

Can you please advise on how to react to this. Does it need nothing, or correcting back flush to the ridge board, or reinforcement with extra ties?
Is it a (mid-span) purlin roof?
 
No purlins, just Rafters. It does have 2 hip rafters at one end (which are also not touching each other or the ridge board, there is a gap between the trio of approx. 5-13mm)
Probably shrinkage then. It's nice to see nice tight joints, but unlikely to be detrimental, up near the ridge. The (nail) fixings are likely to be keeping the plumb cuts from closing and would need a wee thump with the hammer, should you ever strip the roof.
 
bably shrinkage then. It's nice to see nice tight joints, but unlikely to be detrimental, up near the ridge. The (nail) fixings are likely to be keeping the plumb cuts from closing and would need a wee thump with the hammer, should you ever strip the roof.
Thank you so much for the reply.

I also have rafter and jack rafter with cracks. Managed to get decent pictures of these, would these need any rectification ASAP or is it par for the course?
 

Attachments

  • IMG_20261021_105705.jpg
    IMG_20261021_105705.jpg
    717.7 KB · Views: 2
  • IMG_20261021_105559.jpg
    IMG_20261021_105559.jpg
    560.7 KB · Views: 2
Thank you so much for the reply.

I also have rafter and jack rafter with cracks. Managed to get decent pictures of these, would these need any rectification ASAP or is it par for the course?
An expected bit of natural checking. I'd just make sure there is a fixing each side of the check into the hip blade.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top