If you decide to test the old motor on the bench, it should start up quickly and in the same direction every time...I like to test the torque, too so I hold the motor in a vice and grip the spindle whilst switching on.
On a couple of occasions Ive been able to stop the motor from turning!
Check the motor to pump dog drive too - I cant remember what it looks like though.
John
The original was a very short triangular job.
The worst aspects of all these cookers is degradation of the combustion chambers often caused by overfiring as a consequence of poor service regimes and clogged baffles. It did not help that originally that the two layers of each baffle were the same width, and jammed in the heat exchanger. The right hand ones are also under the hob and you can't pull them effectively.
Update on this - New Motor and cap fitted (motor is now slightly different with the cap built on - different make) -- Fired up first time and sounds a lot healthier
Thanks again everyone
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local