8. Hold in the green ON/OFF button on the gas control valve.
9. Press in the igniter button and release. Repeat until the pilot lights. Hold in the green ON/OFF button for approximately 15 seconds and then release. The pilot should then stay alight. If the pilot fails to remain alight then repeat the procedure from 8. The flame should be without a yellow tip and should extend past the pilot shroud by approximately 12mm (1/2in).
10. Turn on the mains electricity supply.
11. Operate the burner by turning the thermostat knob to the no. 6 setting - FULLY CLOCKWISE.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local