Relocating and replacing Stopcock

Joined
28 Jun 2021
Messages
594
Reaction score
17
Country
United Kingdom
Hi
I need to relocate and replace stopcosk in the kitchen. Can I do as in the first photo below? IE: Cancelling the grey stopocck and put in the new location indictaed?
Can I use the Peglar full bore 15mm PN16 shown in second photo?
Any considerations to take into account?
TIA
kitchen .jpeg

Peglar 15mm .jpeg
 
Last edited:
Can I do as in the first photo below? IE: Cancelling the grey stopocck and put in the new location indictaed?
Can I use the Peglar full 15mm PN16 shown in second photo?
Yes to all, as long as the new position leaves enough room for the dishwasher.
 
What about extending into the space to the right, thus leaving access?
Total space is 600mm. The dishwasher is slimmline 450mm wide will be on the left and 150mm base unit on the right. I will put opening at the back of the base unit to access peglar valve handle off and on as required. How does the plan sound??
 
If I was doing the job I'd have to replace the section of copper between the old and new locations so it was a nice 90 degree bend clipped properly anything else would drive me mad.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top