Hi,
I'm trying to replace the batteries in my Odyssey bell box. The instructions for the manual say I need to enter the engineer hold-off mode by doing one of two things:
a) activating and deactivating the strobe 3 times in 30 sections.
b) pressing the omit key when in the bell test menu.
The batteries are now flat so I can't do a)
Do I need to do b) or will all be fine becuase the unit doesn't have any battery power left. If I need to do b) then should I see any response from the control panel when I press omit? I tried this, but the control panel didn't seem to give me a response.
Thanks,
Matthew
I'm trying to replace the batteries in my Odyssey bell box. The instructions for the manual say I need to enter the engineer hold-off mode by doing one of two things:
a) activating and deactivating the strobe 3 times in 30 sections.
b) pressing the omit key when in the bell test menu.
The batteries are now flat so I can't do a)
Do I need to do b) or will all be fine becuase the unit doesn't have any battery power left. If I need to do b) then should I see any response from the control panel when I press omit? I tried this, but the control panel didn't seem to give me a response.
Thanks,
Matthew