Hi. I'm replacing the lights in our kitchen with some new ones. There are two lights which operate off a 2 gang switch, so one switch operates one light, the other operates the second light.
Replacing the first light went OK - there was only a black and red so it was straightforward to connect.
Replacing the second light has been more complicated though. There are 9 lots of wires from the ceiling , 3 red, 3 black and 3 earth: 3 sets of 3 wires. One set of wires gives a reading on my ohm meter when the switches are on, so I'm presuming these are the switch wires. A second set give a reading all the time, which I think means they go to the second light. The third set give no reading at all.
So do I go about connecting the ceiling rose on this second light back up?
Replacing the first light went OK - there was only a black and red so it was straightforward to connect.
Replacing the second light has been more complicated though. There are 9 lots of wires from the ceiling , 3 red, 3 black and 3 earth: 3 sets of 3 wires. One set of wires gives a reading on my ohm meter when the switches are on, so I'm presuming these are the switch wires. A second set give a reading all the time, which I think means they go to the second light. The third set give no reading at all.
So do I go about connecting the ceiling rose on this second light back up?