Risco Nova 2 bell-box hold off

[Carlos67]

Anyone know how to put a Risco Nova 2 bell-box into hold-off mode? It's connected to a Texecom 64w panel.

Wanting to replace the internal battery and a bit of a cleanup. Also possibly change mode to SCB as maybe adding a 2nd Texecom bell-box.

Below is a pic from when the cover was last off but can't remember how I put it into hold off.

 

[sparkymarka]

As far as I know it doesn’t have that feature

 

[Carlos67]

As far as I know it doesn’t have that feature

If I go into engineer mode will that not disable the bell tamper? It disables all the other tampers.

 

[Bigsosij]

It will disable the bell tamper on the panel, but the bell will still sound when u take the lid off

 

[Carlos67]

I guess I'll just have to tape down the bell tamper switch when lid comes off.

 

[Bigsosij]

Or disconnect the 2 red wires

 

[Carlos67]

Or disconnect the 2 red wires

You mean the 12v and bell trigger wire at the main panel? Or do you mean inside the bell-box after cover removed?

 

[Bigsosij]

2 red wires in the bell will do, put new battery in, reconnect red 12v, close lid