Scantronic 9751 Bell Tamper

[Dave Stokes]

Hi All

I have a scantronic 9751 which has a bell tamper. We are having rendering done on the house so i had i remove the bell box from the outside wall. I put the alarm in installer mode and have disconnected the bell box from outside. I also have a sounder on the inside of the house which i am happy to continue to work and i still want to set the alarm at bed time and when we go out, but i now can not exit installer mode due to the bell tamper.

is there a way I can disable the outside bell and then re enable it after work has been completed and the box is back on the house so i can continue to use the alarm as normal?

Thanks

 

[sparkymarka]

Link 0v to TR in the panel

 

[Dave Stokes]

thanks for the reply

I am a user and not an engineer, I don't know what the above is

 

[sparkymarka]

 

[sparkymarka]

Top right hand side of pcb ....outputs ....put a wire link from TR to 0v (aux power )

 

[Dave Stokes]

oh ok, so a wire as per this picture in red







-

 

[sparkymarka]

Yes

 

[Dave Stokes]

thanks will give that a try

 

[Dave Stokes]

thanks this worked