Hi,
I have bought a Titan TTK587GDO strimmer,these are sold by ScrewFix.
It was £10 non runner.
Spark is fine.
Petrol / oil is new.
Spark plug is new.
So i tried to get it started but nothing.
I removed the air filter & give a squirt of carb cleaner down the carb,give it & pull & it started & run until the carb cleaner was gone.
It does this every time.
So i removed the carb & cleaned it with carb cleaner,no gasket / diaphragm look broken.
Put it back together but same issue.
If i pump the primer say 3 times i see fuel being squirted from the little hole in the bottom of the carb,this is the square plate held on by 4 screws & has a circular dish/raised part.
Carb off again & this time another good squirt of carb cleaner down every hole / pipe / drilling.
I just dont see why it wont even start if all is clean.
Any advice.
I have bought a Titan TTK587GDO strimmer,these are sold by ScrewFix.
It was £10 non runner.
Spark is fine.
Petrol / oil is new.
Spark plug is new.
So i tried to get it started but nothing.
I removed the air filter & give a squirt of carb cleaner down the carb,give it & pull & it started & run until the carb cleaner was gone.
It does this every time.
So i removed the carb & cleaned it with carb cleaner,no gasket / diaphragm look broken.
Put it back together but same issue.
If i pump the primer say 3 times i see fuel being squirted from the little hole in the bottom of the carb,this is the square plate held on by 4 screws & has a circular dish/raised part.
Carb off again & this time another good squirt of carb cleaner down every hole / pipe / drilling.
I just dont see why it wont even start if all is clean.
Any advice.