Hi,
We've had some Bifold Doors poorly fit in a rear extension. Internally, there are gaps all round between the profile and the plasterboard and floor of varying widths up to about 10mm in places. As a result, we're losing a load of heat around them and so heating the house is costing a fortune! I'm looking for some advice on the best way to seal around these doors in a way that will block out as much of the draught as possible while remaining relatively low profile.
Thanks in advance
We've had some Bifold Doors poorly fit in a rear extension. Internally, there are gaps all round between the profile and the plasterboard and floor of varying widths up to about 10mm in places. As a result, we're losing a load of heat around them and so heating the house is costing a fortune! I'm looking for some advice on the best way to seal around these doors in a way that will block out as much of the draught as possible while remaining relatively low profile.
Thanks in advance