The plastic backplate should have a rubber seal around the edge. The lights themselves do not need to be sealed to the wall.
Nope, Jon@CmdrBond
my bad then...must have been a different model...its a crackle black finish
yours is just begging for an 'O' ring to go in that annular groove??
you could fill that with silicone first then fix the fitting to the wall
as a precaution i would leave a gap at the bottom for any 'leaks' to drain off
good luck
ps is your name James by any chance..
cheers
geof
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local