I need to cut into the plastic risers on an inspection chamber and was wondering if/how to seal the pipes (110mm). I'm doing it for a back drop pipe, and it's only for rainwater. Do I just use sealant around the pipe or is there something better?
Sealing pipe entering plastic riser?
- Thread starter Peter500
- Start date
- Joined
- 24 Oct 2020
- Messages
- 6,403
- Reaction score
- 2,332
- Country
300mm drain riser?
Not sure what you are connecting to...
You can get 32 and 40mm boss straps for 110mm soil pipe.
You can get 32mm and 40mm rubber bung to take 32mm or 40mm pipe...
You can also buy service plugs they use after drilling hole for camera..
I think drill 32mm hole for rubber and 32mm pipe.
Look up boss strap and fittings.
Maybe something there you can use
Not sure what you are connecting to...
You can get 32 and 40mm boss straps for 110mm soil pipe.
You can get 32mm and 40mm rubber bung to take 32mm or 40mm pipe...
You can also buy service plugs they use after drilling hole for camera..
I think drill 32mm hole for rubber and 32mm pipe.
Look up boss strap and fittings.
Maybe something there you can use
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
