Just had a leaky shower pump replaced with a new one but the wiring is different and the plumber could not figure it out.
The current situation is that as soon as the power is switched-on the pump starts regardless of whether the shower valve is open or not so it suggests that the flow controls are not correctly connected.
The pump is a Salamander CT50 - does anyone have any experience of how the wiring in this should be configured? There is a five-way connecting block inside with an attachment connecting 3 of the blocks together. There is a 4th wire which is currently loose but it is not immediately obvious where it should go and I am reluctant to go for trial and error in case I fry the pump.
Any help gratefully received.
Thanks,
Simon
The current situation is that as soon as the power is switched-on the pump starts regardless of whether the shower valve is open or not so it suggests that the flow controls are not correctly connected.
The pump is a Salamander CT50 - does anyone have any experience of how the wiring in this should be configured? There is a five-way connecting block inside with an attachment connecting 3 of the blocks together. There is a 4th wire which is currently loose but it is not immediately obvious where it should go and I am reluctant to go for trial and error in case I fry the pump.
Any help gratefully received.
Thanks,
Simon