I hope someone can help with this problem.
I've had a Mira Flight Safe shower tray fitted and it has not been laid level. That is, at the waste end it is 1/2 to 3/4 inch too low.
As a result of this my joiner refused, kindly, to fit the enclosure.
My question really is, is it possible to take out the tray without damaging it in order to have it re-done?
The tray is acrylic capped resin and it's laid on a bed of concrete.
I appreciate any replies.
Thank you.
I've had a Mira Flight Safe shower tray fitted and it has not been laid level. That is, at the waste end it is 1/2 to 3/4 inch too low.
As a result of this my joiner refused, kindly, to fit the enclosure.
My question really is, is it possible to take out the tray without damaging it in order to have it re-done?
The tray is acrylic capped resin and it's laid on a bed of concrete.
I appreciate any replies.
Thank you.