Hi,
I would like to spur off an existing socket to supply a new (single) socket, however when investigating I've found that my existing socket is already a spur from the ring main.
After reading various sources it seems that spurring from a spur is a no-no..... (what is the reasoning behind this? because of the current going through two sets of single wires?)
however I was wondering if this is possible if I install a 13A FCU before the first spur so that only a 13A load can be supported
any comments greatfully recevied
I would like to spur off an existing socket to supply a new (single) socket, however when investigating I've found that my existing socket is already a spur from the ring main.
After reading various sources it seems that spurring from a spur is a no-no..... (what is the reasoning behind this? because of the current going through two sets of single wires?)
however I was wondering if this is possible if I install a 13A FCU before the first spur so that only a 13A load can be supported
any comments greatfully recevied