Hi all
I have 1xmains halogen and want to replace one pendant ceiling fitting on a 6a protected light circuit, which has little to any load on it.
Also only two cables coming in, so guessing it's a spur/ end of circuit and one of these two cables is to the switch but cabling does not make this clear. Oh and both cables have a black, red, and earth.
Perhaps it's too simple a query but is below true?
I do not need a junction box
I can use the 1.0 cable there now
I take the set of live cables and connect directly to the downlight
Same for neutral
The downlight says don't connect earth - I still intend joining the ends together just not touching downlight
All good? I had thought of putting in a seperate junction box but seems no need.
I have 1xmains halogen and want to replace one pendant ceiling fitting on a 6a protected light circuit, which has little to any load on it.
Also only two cables coming in, so guessing it's a spur/ end of circuit and one of these two cables is to the switch but cabling does not make this clear. Oh and both cables have a black, red, and earth.
Perhaps it's too simple a query but is below true?
I do not need a junction box
I can use the 1.0 cable there now
I take the set of live cables and connect directly to the downlight
Same for neutral
The downlight says don't connect earth - I still intend joining the ends together just not touching downlight
All good? I had thought of putting in a seperate junction box but seems no need.