I've just started refitting my garage to make it a little more functional. Part of this involves building a workbench and stud framed wall against the far end of the space.
I erected and installed the frame this afternoon but completely forgot about installing a layer of DPM to the back of the studwork.
I'm not planning on insulating or heating the garage, its primary use is storage and occasional workshop duties. Will I get away without the DPM?
I should mention that the studwork is not in direct contact with the blockwork. The frame is packed out at 6mm around the edges with plastic packers and there is a 12mm gap between the rear of the frame and the rear wall.
Ta.
I erected and installed the frame this afternoon but completely forgot about installing a layer of DPM to the back of the studwork.
I'm not planning on insulating or heating the garage, its primary use is storage and occasional workshop duties. Will I get away without the DPM?
I should mention that the studwork is not in direct contact with the blockwork. The frame is packed out at 6mm around the edges with plastic packers and there is a 12mm gap between the rear of the frame and the rear wall.
Ta.